ERPS configuration task list
ERPS does not provide an election mechanism. To implement ring detection and protection, configure all nodes correctly.
To configure ERPS, perform the following tasks:
Task at a glance | Remarks |
---|---|
(Required.) Enabling ERPS globally | N/A |
(Required.) Configuring an ERPS ring | N/A |
(Optional.) Enabling R-APS packets to carry the ring ID in the destination MAC address | N/A |
(Required.) Configuring ERPS ring member ports: | N/A |
(Required.) Configuring control VLANs | N/A |
(Required.) Configuring protected VLANs | N/A |
(Required.) Configuring the node role | N/A |
(Required.) Enabling ERPS for an instance | N/A |
(Optional.) Configuring R-APS packet levels | N/A |
(Optional.) Setting ERPS timers | This task is required only for the owner node. |
(Optional.) Setting the non-revertive mode | This task is required only for the owner node. |
(Optional.) Setting the MS mode | This task is required for the node whose port is blocked. |
(Optional.) Setting the FS mode | This task is required for the node whose port is blocked. |
(Optional.) Associating a ring with a subring | This task is required only for the interconnection node. |
(Optional.) Enabling flush packet transparent transmission | This task is required only for the interconnection node. |
(Optional.) Associating an ERPS ring member port with a track entry | N/A |
(Optional.) Removing the MS mode and FS mode settings for an ERPS ring | N/A |