Configuration procedure
Configure Switch B:
# Enable the IPv6 packet forwarding function.
<SwitchB> system-view [SwitchB] ipv6
# Configure the IPv6 address of VLAN-interface 2.
[SwitchB] interface vlan-interface 2 [SwitchB-Vlan-interface2] ipv6 address 1::1 64
# Set the O flag in the RA messages to 1.
[SwitchB-Vlan-interface2] ipv6 nd autoconfig other-flag
# Enable Switch B to send RA messages.
[SwitchB-Vlan-interface2] undo ipv6 nd ra halt
Configure Switch A:
# Enable the IPv6 packet forwarding function.
<SwitchA> system-view [SwitchA] ipv6
# Enable stateless IPv6 address autoconfiguration on VLAN-interface 2.
[SwitchA] interface vlan-interface 2 [SwitchA-Vlan-interface2] ipv6 address auto
With this command executed, if VLAN-interface 2 has no IPv6 address configured, Switch A will automatically generate a link-local address, and send an RS message, requesting the gateway (Switch B) to reply with an RA message immediately.