Connecting the PSR150-D/PSR150-D1 (JD366A/JD366B) to a –48 VDC power source


[CAUTION: ]

CAUTION:

Identify the positive (+) and negative (-) marks on the two wires to avoid connection mistakes.


To connect the PSR150-D/PSR150-D1 (JD366A/JD366B) to a –48 VDC power source:

  1. Wear an ESD-preventive wrist strap and make sure it makes good skin contact and is well grounded.

  2. Unpack the DC power cord, correctly orient the plug at one end of the cable with the power receptacle on the power supply, and insert the plug into the power receptacle (see callout 1 in Figure 18).

    The power receptacle is foolproof. If you cannot insert the plug into the receptacle, re-orient the plug rather than use excessive force to push it in.

  3. Tighten the screws on the plug with a flat-blade screwdriver to secure the plug in the power receptacle (see callout 2 in Figure 18).

  4. Connect the two wires at the other end of the power cord to a –48 VDC power source.

    Figure 18: Connecting a –48V DC power cord


    [NOTE: ]

    NOTE:

    You can also connect the PSR150-D/PSR150-D1 (JD366A/JD366B) to an RPS that provides –48 VDC output. The connection procedure is the same as described in "Connecting the switch to a –52 to –55 VDC output RPS."