Resetting

The appliance is currently being reset to its original, factory defaults.

After the reset operation is complete, you need to determine the IP address to use in the browser window so that you can log in to the appliance. Do one of the following to configure the appliance:

IMPORTANT:

The factory reset operation is not available while the appliance is highly available. Before you can perform the factory reset operation on the appliance, you must remove the standby appliance. The standby appliance is factory reset as part of the removal operation.

The factory reset operation is not available from the Image Streamer user interface. You can perform the factory reset operation using the maintenance console.

The UI will not be available from any monitor port of the frame link module unless you restore the appliance from a recent backup file. Otherwise you must also perform a factory reset of the frame link module.

If the Maintenance console indicates the Image Streamer appliance is offline and unusable or requires manual action, see Troubleshooting in the HPE Synergy Image Streamer User Guide.