Attach/Detach Restore Points fails when you perform the action through HPE SSMC

Symptom

The restore points that you created using HPE RMC may fail to restore when the Attach/Detach Restore Points action is performed in HPE SSMC.

Cause

This issue can happen if you export or unexport the virtual volumes through any interface other than HPE RMC and RMC is not aware of the current status of the virtual volume. If the virtual volume is exported or unexported to/from a host, the same is not reflected in HPE RMC recovery set.

Action
  1. Go to HPE RMC and refresh the corresponding recovery set to which the virtual volume belongs.
  2. Then retry the action in HPE SSMC.