Networking
The
networking
section consists of two subsections,
underlay
and
overlay
. The
underlay
subsection contains the following blocks of VLAN parameters: ILO-OOBM, vMotion, vSAN, ESXI_MGMT, vCENTER_HA, VM_MGMT, API, OAM, EXTERNAL, PROVIDER-VLAN, and L3-VNI.
The following table describes the parameters in the
underlay
subsection with the example values:
The details of a network are provided as an example in the following table. The remaining networks must be similarly configured.
Parameters | Description |
---|---|
underlay |
Underlay is the Layer 3 (L3) IP network that routes VXLAN packets as normal IP traffic. |
name |
Enter the descriptive name of the corresponding network.
NOTE:
We recommend not to use the same name for multiple networks. |
type |
Type of the network corresponding to the network diagram. This field is autopopulated after JSON generation. |
cidr |
Enter the cidr value based on the customer input. |
description |
Enter the description of the corresponding network. |
gateway |
Enter the gateway value based on the network. |
ip_range_start |
Enter the IP address range based on the server and switch counts. |
ip_range_end |
Enter the IP address range based on the server and switch counts. |
vlan |
Enter the vlan value based on the customer input. |
vlan_range |
The total range of the VLANs that can be used.
NOTE:
This parameter is applicable only to the
|
vxlan |
Enter the vxlan value based on the customer input. |
vxlan_range |
The total range of the VxLANs that can be used.
NOTE:
This parameter is applicable only to the
|
Overlay | The underlay is the Layer 3 (L3) IP network that routes VXLAN packets as normal IP traffic. The overlay refers to the virtual Ethernet segment created by this forwarding. |
name |
Enter the descriptive name of the corresponding network.
NOTE:
We recommend not to use the same name for multiple networks. |
type |
Type of the network corresponding to the network diagram. This field is autopopulated after JSON generation. |
cidr |
Enter the cidr value based on the customer input. |
description |
Enter the description of the corresponding network. |
gateway |
Enter the gateway value based on the network. |
ip_range_start |
Enter the IP address range based on the server and switch counts. |
ip_range_end |
Enter the IP address range based on the server and switch counts. |
vlan |
Enter the vlan value based on the customer input. |
vlan_range |
The total range of the VLANs that can be used.
NOTE:
This parameter is applicable only to the
|
vxlan |
Enter the VxLAN value based on the customer input. |
vxlan_range |
The total range of the VxLANs that can be used.
NOTE:
This parameter is applicable only to the
|
description |
Enter the description of the corresponding network. |