IPv6 addressing configuration


	NOTE: All commands previously in the Summary of commands table are indexed under the entry Command syntax.

More information, see Viewing the current IPv6 addressing configuration, show IPv6 nd output with default settings.

Introduction

In the default configuration, IPv6 operation is disabled on the switch. This section describes the general steps and individual commands for enabling IPv6 operation.

This chapter provides the following:

general steps for IPv6 configuration
IPv6 command syntax descriptions, including show commands

Most IPv6 configuration commands are applied per-VLAN. The exceptions are ICMP, ND, and the (optional) authorized-managers feature, which are configured at the global configuration level. (ICMP and ND for IPv6 are enabled with default values when IPv6 is first enabled and can either be left in their default settings or reconfigured, as needed.)


	NOTE: Beginning with software release K.13.01, the switch is capable of operating in dual-stack mode, where IPv4 and IPv6 run concurrently on a given VLAN.

prev		next
HPE ArubaOS-Switch	home	General configuration steps