Using the destination Commander CLI to pull a member from another stack

stack member switch-number mac-address [ password password-str]

In the destination Commander, finds the MAC address of the Member you want to pull into the destination stack.

Stack listing with two stacks in the subnet

Suppose you create a new Commander with a stack name of Cold_Waters and want to move a switch named Bering Sea into this new stack:

You would then execute the following command to pull the desired switch into the new stack:

HP Switch(config)#: stack member 1 mac-address 0060b0-df1a00

Where 1 is an unused switch number (SN).

Since a password is not set on the Candidate, a password is not needed.

Use show stack all again to verify that the move took place.

prev	up	next
Using a Candidate CLI to push the Candidate into a stack	home	Using a Member CLI to push the Member into another stack