Smart Rate is a new technology designed to enable higher port link speeds on legacy cabling where an Ethernet RJ45 port type can link at 1Gbps, 2.5Gbps, 5Gbps, or 10Gbps.
When situations occur where a network link establishes at a lower than expected speed (or not at all) due to marginal or bad cabling, the Smart Rate port technology allows administrators to triage cabling issues and determine root causes of lower than expected performance.
Smart Rate Technology is available on the following products:
HP Switch 5400R v3 zl2 modules (J9991A, J9995A) |
HP Switch 5400R chassis switch bundles (JL002A) |
Syntax
Displays port diagnostics on a Smart Rate port.
Unlinked Smart Rate port
show interface C5 smartrate Status and Counters - Smart Rate information for Port C5 Model : 0x03a1 Chip : 0xb4b3 Firmware (major) : 0x0002 Firmware (minor) : 0x0003 Firmware (candidate) : 0x0005 Firmware (provision) : 0x0001 Chan1 Chan2 Chan3 Chan4 (in db) Current SNR 9.000000 6.700000 3.500000 9.200000 Minimum SNR 9.000000 6.700000 3.500000 9.200000 CRC8 errors: 0 LDPC errors: 0 LDPC 1 iteration: 27620089 LDPC 2 iterations: 954117 LDPC 3 iterations: 0 LDPC 4 iterations: 0 LDPC 5 iterations: 0 LDPC 6 iterations: 0 LDPC 7 iterations: 0 LDPC 8 iterations: 0 23 Number of fast retrains requested by Local Device. 32 Number of fast retrains requested by Link Partner. 150 Accumulated time (ms) spent in fast retrain since last AN. 9 Number of RFI Training Link Recovery Events since last AN. 3 Number of Link Recover Events since last AN. Established link speed : 5000Mbps Number of attempts to establish link : 5 Uptime since link was last established (ms) : 5099 Local port advertised speeds 1000Mbps 2500Mbps 5000Mbps 10Gbps No Yes Yes No Link partner speed capability 1000Mbps 2500Mbps 5000Mbps 10Gbps Yes Yes Yes No Link Partner matching vendor: YesSmart Rate port that is linked at 1Gbps
show interface C5 smartrate Status and Counters - Smart Rate information for Port C5 Model : 0x03a1 Chip : 0xb4b3 Firmware (major) : 0x0002 Firmware (minor) : 0x0003 Firmware (candidate) : 0x0005 Firmware (provision) : 0x0001 Established link speed :1000Mbps Number of attempts to establish link :5 Uptime since link was last established (ms) : 5099 Local port advertised speeds 1000Mbps 2500Mbps 5000Mbps 10Gbps No No No No Link partner speed capability 1000Mbps 2500Mbps 5000Mbps 10Gbps Yes Yes Yes Yes Link Partner matching vendor: Yes
When the show interface
command is run on a non-Smart Rate port, the command will fail with an error message similar to the following: PORT-LIST
smartratePort A1: This command is only applicable to Smart Rate ports.
When the show interface
command is run on a Smart Rate port, but is unable to retrieve all results the command will fail with an error message similar to the following: PORT-LIST
smartratePort A1: This command did not complete successfully. Please try again.