telnet client source
Use telnet client source to specify a source IPv4 address or source interface for outgoing Telnet packets when the device serves as a Telnet client.
Use undo telnet client source to remove the configuration.
Syntax
telnet client source { interface interface-type interface-number | ip ip-address }
undo telnet client source
Default
No source IPv4 address or source interface is specified for outgoing Telnet packets. The source IPv4 address is the primary IPv4 address of the outbound interface.
Views
System view
Predefined user roles
network-admin
mdc-admin
Parameters
interface interface-type interface-number: Specifies a source interface. The primary IPv4 address of the interface will be used as the source IPv4 address for outgoing Telnet packets.
ip ip-address: Specifies a source IPv4 address.
Usage guidelines
This command is not supported in FIPS mode.
The source IPv4 address or source interface that is specified by this command applies to all Telnet connections. However, if a user specifies a source IPv4 address or source interface when executing the telnet command, the setting specified by the user takes effect.
Examples
# Set the source IPv4 address for outgoing Telnet packets to 1.1.1.1 when the device serves as a Telnet client.
<Sysname> system-view [Sysname] telnet client source ip 1.1.1.1
Related commands
display telnet client configuration