snmp-agent trap enable evi-isis

Use snmp-agent trap enable evi-isis to enable EVI IS-IS notifications.

Use undo snmp-agent trap enable evi-isis to disable EVI IS-IS notifications.

Syntax

snmp-agent trap enable evi-isis [ adjacency-state-change | area-mismatch | buffsize-mismatch | id-length-mismatch | link-disconnect | lsp-parse-error | lsp-size-exceeded | max-seq-exceeded | maxarea-mismatch | new-ded | own-lsp-purge | protocol-support | rejected-adjacency | skip-sequence-number | topology-change | version-skew ] *

undo snmp-agent trap enable evi-isis [ adjacency-state-change | area-mismatch | buffsize-mismatch | id-length-mismatch | link-disconnect | lsp-parse-error | lsp-size-exceeded | max-seq-exceeded | maxarea-mismatch | new-ded | own-lsp-purge | protocol-support | rejected-adjacency | skip-sequence-number | topology-change | version-skew ] *

Default

EVI IS-IS notification sending is enabled.

Views

System view

Predefined user roles

network-admin

mdc-admin

Parameters

adjacency-state-change: Specifies notifications about EVI IS-IS adjacency status changes.

area-mismatch: Specifies notifications about area address mismatches between hello packets.

buffsize-mismatch: Specifies notifications about buffer size mismatches for LSPs.

id-length-mismatch: Specifies notifications about system ID length mismatches of EVI IS-IS packets.

link-disconnect: Specifies notifications about EVI link failures.

lsp-parse-error: Specifies notifications about LSP parse failures.

lsp-size-exceeded: Specifies notifications about propagation failures caused by oversized LSPs.

max-seq-exceeded: Specifies notifications about attempts to exceed with the maximum LSP sequence number.

maxarea-mismatch: Specifies notifications about maximum area address mismatches of hello packets.

new-ded: Specifies notifications about the device's being elected as the DED.

own-lsp-purge: Specifies notifications about attempts to remove the local LSP.

protocol-support: Specifies notifications about supported-protocol mismatches for non-pseudo node LSPs.

rejected-adjacency: Specifies notifications about adjacency creation failures.

skip-sequence-number: Specifies notifications about LSP sequence number duplications.

topology-change: Specifies notifications about edge device topology changes at the local site. This notification will not be sent if a new-ded notification has been sent for the same vent.

version-skew: Specifies notifications about hello packet version mismatches.

Usage guidelines

If you do not specify a notification, this command enables all EVI IS-IS notifications.

To report critical EVI IS-IS events to an NMS, enable SNMP notifications for EVI IS-IS. For EVI IS-IS event notifications to be sent correctly, you must also configure SNMP as described in Network Management and Monitoring Configuration Guide.

Examples

# Enable EVI IS-IS adjacency status change notifications.

<Sysname> system-view
[Sysname] snmp-agent trap enable evi-isis adjacency-state-change