EVI commands

EVI requires a license. For more information about feature licensing, see Fundamentals Configuration Guide.

Before you can configure EVI, you must perform the following tasks:

1. Set the system operating mode to advanced by using the system-working-mode advance command.

2. Save the configuration.

3. Delete the binary .mdb next-startup configuration file.

4. Reboot the device.

For more information about setting the system operating mode, see device management in Fundamentals Configuration Guide.

The HPE 7904 (JG682A) or HPE 7904 TAA (JH122A) switch uses one built-in MPU (slot 0) and the HPE 7910 (JG841A) or HPE 7910 TAA (JH123A) switch uses two removable switching fabric modules (slots 10 and 11) for switching and control.

Unless otherwise stated, the term "card" collectively refers to LPUs, switching fabric modules, and MPUs.