Configuration task list
To use CWMP, you must enable CWMP from the CLI. You can then configure ACS and CPE attributes from the CPE's CLI, the DHCP server, or the ACS.
For an attribute, the CLI- and ACS-assigned values have higher priority than the DHCP-assigned value. The CLI- and ACS-assigned values overwrite each other, whichever is assigned later.
This document only describes configuring ACS and CPE attributes from the CLI and DHCP server. For more information about configuring and using the ACS, see ACS documentation.
To configure CWMP, perform the following tasks:
Tasks at a glance | Remarks |
---|---|
(Required.) Enabling CWMP from the CLI | To use CWMP, you must enable CWMP from the CLI. |
The preferred ACS attributes are configurable from the CPE's CLI, DHCP server, and ACS. The default ACS attributes are configurable only from the CLI. | |
(Optional.) Configuring CPE attributes: | All CPE attributes are configurable from the CLI and ACS except for the following attributes:
These attributes are configurable only from the CLI. |