Configuring NTP in symmetric active/passive mode
Follow these guidelines when you configure a symmetric-active peer:
For a symmetric-passive peer to process NTP messages from a symmetric-active peer, execute the ntp-service enable command on the symmetric passive peer to enable NTP.
For time synchronization between the symmetric-active peer and the symmetric-passive peer, make sure either or both of them are in synchronized state.
You can configure multiple symmetric-passive peers by executing the ntp-service unicast-peer or ntp-service ipv6 unicast-peer command multiple times.
When the device operates in symmetric active/passive mode, specify on a symmetric-active peer the IP address for a symmetric-passive peer.
To configure a symmetric-active peer:
Step | Command | Remarks |
---|---|---|
1. Enter system view. | system-view | N/A |
2. Specify a symmetric-passive peer for the device. |
| By default, no symmetric-passive peer is specified. |