display spbm multicast-pw
Use display spbm multicast-pw to display multicast pseudo wires (PWs).
Syntax
display spbm multicast-pw [ i-sid i-sid ] [ count ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
i-sid i-sid: Specifies an I-SID in the range of 255 to 16777215. If you do not specify an I-SID, the command displays multicast PW information for all I-SIDs.
count: Displays the total number of multicast PWs. If you do not specify this keyword, the command only displays multicast PW information.
Usage guidelines
Use this command on a BEB that uses tandem replication to verify multicast PW information.
The multicast PW table is empty on the following SPBM nodes:
BEBs that use head-end replication—Head-end replication does not require multicast PWs because frames are tunneled in unicast frames.
BCBs—BCBs do not maintain PWs because multicast PWs are established between BEBs.
Examples
# Display all multicast PWs.
<Sysname> display spbm multicast-pw System ID I-SID MAC address B-VLAN Port 0011.2200.0101 300 0300-0a00-012c 10 FGE1/0/1 FGE1/0/2
Table 20: Command output
Field | Description |
---|---|
System ID | System ID of the remote BEB. |
I-SID | SPBM VSI identifier. |
MAC address | Destination multicast MAC address for frames to be tunneled. |
B-VLAN | B-VLAN to be encapsulated for frames to be tunneled. |
Port | Outgoing interfaces. |
# Display the total number of multicast PWs.
<Sysname> display spbm multicast-pw count Total entries: 2