Configuring DLSw tests
DLSw tests of an NQA test group are used to test the response time of a DLSw device.
Before you start DLSw tests, enable the DLSw function on the peer device.
To configure DLSw tests:
Step | Command | Remarks |
---|---|---|
1. Enter system view. | system-view | N/A |
2. Enter NQA test group view. | nqa entry admin-name operation-tag | N/A |
3. Configure the test type as DLSw, and enter test type view. | type dlsw | N/A |
4. Configure the destination address of probe packets. | destination ip ip-address | By default, no destination IP address is configured. |
5. Configure the source IP address of probe packets. | source ip ip-address | Optional. By default, no source IP address is specified. The source IP address must be the IP address of a local interface. The local interface must be up. Otherwise, no probe packets can be sent out. |
6. Configure optional parameters. | Optional. |