Configuring NMS login
Connect the Ethernet port of the PC to an Ethernet port of VLAN 1 of the device, as shown in Figure 28. Make sure the PC and VLAN 1 interface can reach each other.
Figure 28: Network diagram for configuring NMS login
Follow these steps to configure SNMPv3 settings:
To do… | Use the command… | Remarks |
---|---|---|
Enter system view | system-view | — |
Enable SNMP agent | snmp-agent | Optional Disabled by default. You can enable SNMP agent with this command or any command that begins with snmp-agent. |
Configure an SNMP group and specify its access right | snmp-agent group v3 group-name [ authentication | privacy ] [ read-view read-view ] [ write-view write-view ] [ notify-view notify-view ] [ acl acl-number ] | Required By default, no SNMP group is configured. |
Add a user to the SNMP group | snmp-agent usm-user v3 user-name group-name [ [ cipher ] authentication-mode { md5 | sha } auth-password [ privacy-mode { 3des | aes128 | des56 } priv-password ] ] [ acl acl-number ] | Required If the cipher keyword is specified, both auth-password and priv-password are cipher text passwords. |
Follow these steps to configure SNMPv1 and SNMPv2c settings:
To do… | Use the command… | Remarks | ||
---|---|---|---|---|
Enter system view | system-view | — | ||
Enable SNMP agent | snmp-agent | Optional Disabled by default. You can enable SNMP agent with this command or any command that begins with snmp-agent. | ||
Create or update MIB view information | snmp-agent mib-view { excluded | included } view-name oid-tree [ mask mask-value ] | Optional By default, the MIB view name is ViewDefault and OID is 1. | ||
Configure SNMP NMS access right | Directly | Configure an SNMP community | snmp-agent community { read | write } community-name [ acl acl-number | mib-view view-name ]* | Required Use either approach. The direction configuration approach is for SNMPv1 or SNMPv2C. The community name configured on the NMS should be consistent with the username configured on the agent. The indirect configuration approach is for SNMPv3. |
Indirectly | Configure an SNMP group | snmp-agent group { v1 | v2c } group-name [ read-view read-view ] [ write-view write-view ] [ notify-view notify-view ] [ acl acl-number ] | ||
Add a user to the SNMP group | snmp-agent usm-user { v1 | v2c } user-name group-name [ acl acl-number ] |
NOTE: The device supports three SNMP versions: SNMPv1, SNMPv2c and SNMPv3. For more information about SNMP, see the Network Management and Monitoring Configuration Guide. | ||