HTTP login example

	NOTE: This example is not supported in FIPS mode.

As shown in Figure 26, the PC is connected to the device over an IP network. The IP address of the Device is 192.168.0.58/24.

1. Configuration on the device

# Log in to the device via the console port and configure the IP address of VLAN 1 of the device. VLAN 1 is the default VLAN.

<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-VLAN-interface1] ip address 192.168.0.58 255.255.255.0
[Sysname-VLAN-interface1] quit

# Create a local user named admin, and set the password to admin for the user. Specify the telnet service type for the local user, and set the command level to 3 for this user.

[Sysname] local-user admin
[Sysname-luser-admin] service-type telnet 
[Sysname-luser-admin] authorization-attribute level 3
[Sysname-luser-admin] password simple admin

1. Configuration on the PC

# On the PC, run the web browser. Enter the IP address of the device in the address bar, 192.168.0.58 in this example. The web login page appears.

# Type the user name, password, verify code, select English, and click Login. The homepage appears. After login, you can configure device settings through the web interface.