lldp compliance admin-status cdp (available only on the HPE 3100 v2 EI)
Syntax
lldp compliance admin-status cdp { disable | txrx }
undo lldp compliance admin-status cdp
View
Layer 2 Ethernet interface view, port group view
Default level
2: System level
Parameters
disable: Specifies the disable mode. CDP-compatible LLDP in this mode cannot receive or transmit CDP packets.
txrx: Specifies the TxRx mode. CDP-compatible LLDP in this mode can send and receive CDP packets.
Description
Use lldp compliance admin-status cdp to configure the operating mode of CDP-compatible LLDP on a port or port group.
Use undo lldp compliance admin-status cdp to restore the default.
By default, CDP-compatible LLDP operates in disable mode.
For your device to work with Cisco IP phones, you must perform the following tasks:
Enable CDP-compatible LLDP globally.
Configure CDP-compatible LLDP to operate in TxRx mode on the specified ports.
Related commands: lldp compliance cdp.
Examples
# Configure CDP-compatible LLDP to operate in TxRx mode on Ethernet 1/0/1.
<Sysname> system-view [Sysname] interface ethernet 1/0/1 [Sysname-Ethernet1/0/1] lldp compliance admin-status cdp txrx