port trunk pvid
Syntax
port trunk pvid vlan vlan-id
undo port trunk pvid
View
Layer 2 Ethernet interface view, port group view, Layer 2 aggregate interface view
Default level
2: System level
Parameters
vlan-id: Specifies a VLAN ID, in the range of 1 to 4094
Description
Use port trunk pvid to configure the PVID for the trunk port.
Use undo port trunk pvid to restore the default.
By default, the PVID of a trunk port is VLAN 1.
You can use a nonexistent VLAN as the PVID for a trunk port. If you use the undo vlan command to remove the PVID of a hybrid port, it does not affect the setting of the PVID on the port.
The configuration made in Layer 2 Ethernet interface view applies only to the port.
The configuration made in port group view applies to all ports in the port group.
The configuration made in Layer 2 aggregate interface view applies to the aggregate interface and its aggregation member ports.
If the system fails to apply the configuration to the aggregate interface, it stops applying the configuration to aggregation member ports.
If the system fails to apply the configuration to an aggregation member port, it skips the port and moves to the next member port.
The local and remote trunk ports must use the same PVID for the traffic of the PVID to be transmitted properly.
You must use the port trunk permit vlan command to configure the trunk port to allow and forward packets from the PVID.
Related commands: port link-type and port trunk permit vlan.
Examples
# Configure VLAN 100 as the PVID of the trunk port Ethernet 1/0/1.
<Sysname> system-view [Sysname] interface ethernet 1/0/1 [Sysname-Ethernet1/0/1] port link-type trunk [Sysname-Ethernet1/0/1] port trunk pvid vlan 100
# Configure VLAN 100 as the PVID of the trunk Layer 2 aggregate interface Bridge-Aggregation 1.
<Sysname> system-view [Sysname] interface bridge-aggregation 1 [Sysname-Bridge-Aggregation1] port link-type trunk [Sysname-Bridge-Aggregation1] port trunk pvid vlan 100