link-delay
Syntax
link-delay delay-time
undo link-delay
View
Ethernet interface view
Default level
2: System level
Parameters
delay-time: Sets the physical state change suppression interval on the Ethernet interface, ranging from 2 to 10 seconds.
Description
Use link-delay to set the physical state change suppression interval on an Ethernet interface.
Use undo link-delay to restore the default.
By default, the physical state change suppression interval on an Ethernet interface is 0 seconds.
Do not use this command on Ethernet interfaces with RRPP, MSTP, or Smart Link enabled.
NOTE: This command does not apply to ports that are administratively shut down (with the shutdown command). | ||
Examples
# Enable physical state change suppression on Ethernet 1/0/1, setting the suppression interval to 8 seconds.
<Sysname> system-view [Sysname] interface ethernet 1/0/1 [Sysname-Ethernet1/0/1] link-delay 8