http-flood threshold

Use http-flood threshold to set the global threshold for triggering HTTP flood attack prevention.

Use undo http-flood threshold to restore the default.


http-flood threshold threshold-value

undo http-flood threshold


The global threshold is 1000 for triggering HTTP flood attack prevention.


Attack defense policy view

Predefined user roles




threshold-value: Specifies the threshold value. The value range is 1 to 1000000 in units of HTTP packets sent to an IP address per second.

Usage guidelines

With global HTTP flood attack detection configured, the device is in attack detection state. When the sending rate of HTTP packets to an IP address reaches the threshold, the device enters prevention state and takes the specified actions. When the rate is below the silence threshold (three-fourths of the threshold), the device returns to the attack detection state.

The global threshold applies to global HTTP flood attack detection. Adjust the threshold according to the application scenarios. If the number of HTTP packets sent to a protected HTTP server is normally large, set a large threshold. A small threshold might affect the server services. For a network that is unstable or susceptible to attacks, set a small threshold.


# Set the global threshold to 100 for triggering HTTP flood attack prevention in attack defense policy atk-policy-1.

<Sysname> system-view
[Sysname] attack-defense policy atk-policy-1
[Sysname-attack-defense-policy-atk-policy-1] http-flood threshold 100

Related commands

http-flood action

http-flood detect

http-flood detect non-specific