Static SR over MPLS configuration task list
To configure static SR over MPLS, perform the following tasks:
Enable MPLS TE on each node and interface that the MPLS TE tunnel traverses.
Create a tunnel interface on the ingress node of the MPLS TE tunnel, and specify the tunnel destination address as the address of the egress node.
Create a static SRLSP on the ingress node of the MPLS TE tunnel.
On the ingress node of the MPLS TE tunnel, bind the created static SRLSP to the MPLS TE tunnel interface.
On the ingress node of the MPLS TE tunnel, configure static routing or PBR to direct traffic to the MPLS TE tunnel.
Configure adjacency paths on each transit node that the MPLS TE tunnel traverses for the static SRLSP.
Specify the incoming label on the egress node.
For information about configuring MPLS TE, see "Configuring MPLS TE." For information about specifying the incoming label, see "Configuring CRLSP."
The following table lists the SRLSP-specific tasks: