Configuring an MPLS TE tunnel to use a static CRLSP
To configure an MPLS TE tunnel to use a static CRLSP, perform the following tasks:
Establish the static CRLSP.
Specify the MPLS TE tunnel establishment mode as static.
Configure the MPLS TE tunnel to use the static CRLSP.
Other configurations, such as tunnel constraints and IGP extension, are not needed.
To configure an MPLS TE tunnel to use a static CRLSP:
Step | Command | Remarks |
---|---|---|
1. Enter system view. | system-view | N/A |
2. Create a static CRLSP. | See "Configuring a static CRLSP." | N/A |
3. Enter MPLS TE tunnel interface view. | interface tunnel tunnel-number [ mode mpls-te ] | Execute this command on the ingress node. |
4. Specify the MPLS TE tunnel establishment mode as static. | mpls te signaling static | By default, MPLS TE uses RSVP-TE to establish a tunnel. |
5. Apply the static CRLSP to the tunnel interface. | mpls te static-cr-lsp lsp-name | By default, a tunnel does not use any static CRLSP. |