Configuring Hello parameters
Perform this task to set the following hello timers:
Link Hello hold time and Link Hello interval.
Targeted Hello hold time and Targeted Hello interval for a peer.
Setting Link Hello timers
Step | Command | Remarks |
---|---|---|
1. Enter system view. | system-view | N/A |
2. Enter the view of the interface where you want to establish an LDP session. | interface interface-type interface-number | N/A |
3. Set the Link Hello hold time. | mpls ldp timer hello-hold timeout | By default, the Link Hello hold time is 15 seconds. |
4. Set the Link Hello interval. | mpls ldp timer hello-interval interval | By default, the Link Hello interval is 5 seconds. |
Setting Targeted Hello timers for an LDP peer
Step | Command | Remarks |
---|---|---|
1. Enter system view. | system-view | N/A |
2. Enter LDP view. | mpls ldp | N/A |
3. Specify an LDP peer and enter LDP peer view. The device will send unsolicited Targeted Hellos to the peer and can respond to the Targeted Hellos received from the peer. | targeted-peer ipv4-address | By default, the device does not send Targeted Hellos to any peers, or respond to Targeted Hellos received from any peers. |
4. Set the Targeted Hello hold time. | mpls ldp timer hello-hold timeout | By default, the Targeted Hello hold time is 45 seconds. |
5. Set the Target Hello interval. | mpls ldp timer hello-interval interval | By default, the Targeted Hello interval is 15 seconds. |