timer join-prune (PIM view)
Use timer join-prune to set the join/prune interval globally.
Use undo timer join-prune to restore the default.
Syntax
timer join-prune interval
undo timer join-prune
Default
The join/prune interval is 60 seconds.
Views
PIM view
Predefined user roles
network-admin
Parameters
interval: Specifies a join/prune interval in the range of 0 to 18000 seconds. If you set the value to 0 seconds, the device does not send join or prune messages.
Usage guidelines
You can set the join/prune interval globally for all interfaces in PIM view or for an interface in interface view. For an interface, the interface-specific configuration takes priority over the global configuration.
The configuration takes effect after the current interval ends.
To prevent the upstream neighbors from expiring, you must set the join/prune interval to be less than the joined/pruned state holdtime.
Examples
# Set the global join/prune interval to 80 seconds on the public network.
<Sysname> system-view [Sysname] pim [Sysname-pim] timer join-prune 80
Related commands
holdtime join-prune (PIM view)
pim timer join-prune