pim timer join-prune
Use pim timer join-prune to set the join/prune interval on an interface.
Use undo pim timer join-prune to restore the default.
Syntax
pim timer join-prune interval
undo pim timer join-prune
Default
The join/prune interval is 60 seconds.
Views
Interface view
Predefined user roles
network-admin
Parameters
interval: Specifies a join/prune interval in the range of 0 to 18000 seconds. If you set the value to 0 seconds, the interface does not send join or prune messages.
Usage guidelines
You can set the join/prune interval for an interface in interface view or globally for all interfaces in PIM view. For an interface, the interface-specific configuration takes priority over the global configuration.
The configuration takes effect after the current interval ends.
To prevent the upstream neighbors from aging out, you must set the join/prune interval to be less than the joined/pruned state holdtime.
Examples
# Set the join/prune interval to 80 seconds on VLAN-interface 100.
<Sysname> system-view [Sysname] interface vlan-interface 100 [Sysname-Vlan-interface100] pim timer join-prune 80
Related commands
pim holdtime join-prune
timer join-prune (PIM view)