acl hardware-mode ipv6

Use acl hardware-mode ipv6 to enable or disable IPv6 for the ACL hardware mode.

Syntax

acl hardware-mode ipv6 { disable | enable }

Default

IPv6 is disabled for the ACL hardware mode.

Views

System view

Predefined user roles

network-admin

mdc-admin

Parameters

disable: Disables IPv6 for the ACL hardware mode. When IPv6 is disabled, the card supports only IPv4 basic, IPv4 advanced, and Ethernet frame header ACLs.

enable: Enables IPv6 for the ACL hardware mode. When IPv6 is enabled, the card supports IPv4 basic, IPv4 advanced, Ethernet frame header, IPv6 basic, IPv6 advanced, and user-defined ACLs.

Usage guidelines

This command applies to only EC1 cards, EF cards, or FG cards.

After configuring this command, to make the configuration take effect, you must save it and then restart the device.

The ACL hardware mode must be same on all IRF member devices. Otherwise, the devices cannot form an IRF fabric. For more information about IRF, see Virtual Technologies Configuration Guide.

This command is supported only by the default MDC. For more information about MDC, see Virtual Technologies Configuration Guide.

Examples

# Enable IPv6 for the ACL hardware mode.

<Sysname> system-view
[Sysname] acl hardware-mode ipv6 enable

Related commands

display acl hardware-mode