trill designated-vlan
Use trill designated-vlan to configure a designated VLAN.
Use undo trill designated-vlan to restore the default.
Syntax
trill designated-vlan vlan-id
undo trill designated-vlan
Default
No designated VLAN is configured. The system automatically selects an enabled VLAN as the designated VLAN.
Views
Layer 2 Ethernet interface view
Layer 2 aggregate interface view
Predefined user roles
network-admin
mdc-admin
Parameters
vlan-id: Specifies a VLAN ID in the range of 1 to 4094.
Usage guidelines
RBs send Hello frames in a set of VLANs. The VLAN set is calculated as follows:
DRB—Enabled VLANs ∩ (announcing VLANs ∪ designated VLAN).
Non-DRB—Enabled VLANs ∩ (designated VLAN ∪ (announcing VLANs ∩ forwarding VLANs)).
RBs use the designated VLAN to forward TRILL protocol frames (except Hello frames) and local data frames. For RBs to establish adjacencies and forward TRILL data frames, make sure the designated VLAN is an enabled VLAN.
Configuration in Layer 2 Ethernet interface view takes effect only on the current port. Configuration in Layer 2 aggregate interface view takes effect on the current interface and its member ports. Configuration on the member port of an aggregate interface takes effect after the member port leaves the aggregation group.
Examples
# Set VLAN 2 to the designated VLAN.
<Sysname> system-view [Sysname] interface [Sysname-] trill designated-vlan 2
Related commands
trill announcing-vlan