trill cost
Use trill cost to set the link cost for a TRILL port.
Use undo trill cost to restore the default.
Syntax
trill cost cost-value
undo trill cost
Default
The link cost for a TRILL port is 2000.
Views
Layer 2 Ethernet interface view
Layer 2 aggregate interface view
Predefined user roles
network-admin
mdc-admin
Parameters
cost-value: Specifies a link cost in the range of 1 to 16777214.
Usage guidelines
The link cost for a TRILL port can be automatically calculated by the system or manually set.
A manually set link cost takes precedence over a calculated link cost.
If no link cost is set and automatic link cost calculation is enabled, the calculated link cost takes effect.
If no link cost is set and automatic link cost calculation is disabled, the default link cost of 2000 is used.
If you manually set the link cost for a TRILL port, make sure its peer TRILL port uses the same link cost.
Configuration in Layer 2 Ethernet interface view takes effect only on the current port. Configuration in Layer 2 aggregate interface view takes effect on the current interface and its member ports. Configuration on the member port of an aggregate interface takes effect after the member port leaves the aggregation group.
Examples
# Set the link cost to 20000 for TRILL port .
<Sysname> system-view [Sysname] interface [Sysname-] trill cost 20000
Related commands
auto-cost enable