Setting the LLDP operating mode

1. Enter system view.

system-view

N/A

2. Enter Layer 3 Ethernet interface view or Layer 3 aggregate interface view.

interface interface-type interface-number

N/A

3. Set the LLDP operating mode.

• In Layer 3 Ethernet interface view:lldp [ agent { nearest-customer | nearest-nontpmr } ] admin-status { disable | rx | tx | txrx }

• In Layer 3 aggregate interface view:lldp agent { nearest-customer | nearest-nontpmr } admin-status { disable | rx | tx | txrx }

By default:

• The nearest bridge agent operates in txrx mode.

• The nearest customer bridge agent and nearest non-TPMR bridge agent operate in disable mode.

In Ethernet interface view, if you do not specify an agent type, the command sets the operating mode for nearest bridge agents.

In aggregate interface view, you can set the operating mode only for nearest customer bridge agents and nearest non-TPMR bridge agents.