Configuring 802.1X > Specifying an access control method

Specifying an access control method

You can specify port-based or MAC-based access control method for 802.1X authentication. The MAC-based access control method is supported only on the following ports:

Layer 2 Ethernet ports on the following modules:
- HMIM-8GSW.
- HMIM-24GSW.
- HMIM-24GSWP.
- SIC-4GSW.
- SIC-4GSWP
Fixed Layer 2 Ethernet ports on the following routers:
- MSR954 (JH296A/JH297A/JH298A/JH299A/JH373A).
- MSR958 (JH300A/JH301A).
- MSR2004-24/2004-48.
- MSR1002-4/1003-8S.

To specify an access control method:

Step	Command	Remarks
1. Enter system view.	system-view	N/A
2. Enter Ethernet interface view.	interface interface-type interface-number	N/A
3. Specify an access control method.	dot1x port-method { macbased \| portbased }	By default, MAC-based access control applies.

prev	up	next
Setting the port authorization state	home	Setting the maximum number of concurrent 802.1X users on a port

© Copyright 2017 Hewlett Packard Enterprise Development LP