Configuring ambiguous Dot1q termination

1. Enter system view.

system-view

N/A

2. Enter interface view.

• Enter Layer 3 Ethernet subinterface view:interface interface-type interface-number.subnumber

• Enter Layer 3 aggregate subinterface view:interface route-aggregation interface-number.subnumber

• Enter L2VE subinterface view:interface ve-l2vpn interface-number.subnumber

• Enter L3VE subinterface view:interface ve-l3vpn interface-number.subnumber

N/A

3. Configure ambiguous Dot1q termination.

vlan-type dot1q vid vlan-id-list [ loose ]

By default, Dot1q termination is disabled on a subinterface.