show interface tunnel
Syntax
show interface tunnel[<TUNNEL-NUMBER>] [vsx-peer]
Description
Shows configuration settings for all IP tunnels, or a specific tunnel.
Command context
Manager (#)
Parameters
<TUNNEL-NUMBER>
Specifies the number of an IP tunnel. Range: 1 to 127.
[vsx-peer]
Shows the output from the VSX peer switch. If the switches do not have the VSX configuration or the ISL is down, the output from the VSX peer switch is not displayed. This parameter is available on switches that support VSX.
Authority
Operators or Administrators or local user group members with execution rights for this command. Operators can execute this command from the operator context (>) only.
Examples
Shows configuration settings for tunnel 12, which is an IPv6 in IPv6 tunnel in the following example.
switch# show interface tunnel12 Interface tunnel12 is up Admin state is up tunnel type IPv6 in IPv6 tunnel interface IPv6 address 4::1/64 tunnel source IPv6 address 2::1 tunnel destination IPv6 address 2::2 tunnel ttl 60 Description: Network2 Tunnel RX 0 input packets 0 bytes 0 dropped TX 0 output packets 0 bytes 0 dropped