show ubt state


show ubt state [uac-ip <UAC-ADDR>]


Shows the UBT state.

Command context



uac-ip <UAC-ADDR>

Specifies the IP address of the user anchor controller for which to view user information. Specify the address in IPv4 format (x.x.x.x), where x is a decimal number from 0 to 255.


Operators or Administrators or local user group members with execution rights for this command. Operators can execute this command from the operator context (>) only.


On the 6400 Switch Series, interface identification differs.

Showing UBT state:

switch# show ubt state
Local Master Server (LMS) State:

LMS Type      IP Address    State
Primary     : ready_for_bootstrap
Secondary   : ready_for_bootstrap

Switch Anchor Controller (SAC) State:

              IP Address      MAC Address          State
Active      :    00:5a:5e:a3:75:21    Registered

User Anchor Controller(UAC):

User               Port    State                          Bucket ID  Gre Key
a4:b3:25:cb:50:ba   2/1/3  registered                     33         67

Showing user information on the UAC with IP address

switch# show ubt state uac-ip

User Anchor Controller(UAC): 
User                          Port       VLAN    Gre Key   State 
00:00:0a:1a:12:03             11/1/5     400     2         registered