show interface

Syntax

show interfaces <LAG-NAME> [vsx-peer]

Description

Displays information about a specific LAG.

Command context

Operator (>) or Manager (#)

Parameters

<LAG-NAME>

Specifies a LAG name.

[vsx-peer]

Shows the output from the VSX peer switch. If the switches do not have the VSX configuration or the ISL is down, the output from the VSX peer switch is not displayed.

Authority

Operators or Administrators. Users without administrator authority can execute this command from the operator context (>) only.

Examples

Displaying information about LAG 100:

switch# show interface lag100
Aggregate lag100 is up
 Admin state is up
 Description :
 MAC Address                 : 48:0f:cf:af:43:9c
 Aggregated-interfaces       : 1/1/2
 Aggregation-key             : 100
 Aggregate mode              : active
 Speed                       : 2000 Mb/s
 L3 Counters: Rx Disabled, Tx Disabled
 qos trust none
 VLAN Mode: access
 Access VLAN: 1
 Rx
           20 input packets           2584 bytes
            0 input error                0 dropped
            0 CRC/FCS
 Tx
           45 output packets          5658 bytes
            0 input error                4 dropped
            0 collision