rp-address <IPv6-ADDR>

Syntax

rp-address <IPv6-ADDR> [<GRP-ADDR/GRP-MASK>] [override]

no rp-address <IPv6-ADDR> [<GRP-ADDR/GRP-MASK>] [override]

Description

Statically configures the router as the RP for a specified multicast group or range of multicast groups. This must be configured on all PIM-SM routers in the domain. If group address is not specified, it applies to all IPv6 multicast addresses.

The no form of this command removes static RP configuration and its precedence.

Command context

config-pim

Parameters

<IPv6-ADDR>

Specifies the IPv6 address of the static RP. Format: X:X::X:X

<GRP-ADDR/GRP-MASK>

Specifies the range of multicast group addresses associated with the static RP. Default: 224.0.0.0/4. Format: X:X::X:X/M

override

Specifies higher precedence to static RP over Candidate RP.

Authority

Administrators

Usage

Where a static RP and a C-RP are configured to support the same multicast groups and the multicast group mask for the static RP is equal to or greater than the same mask for the applicable C-RPs, this command assigns the higher precedence to the static RP, resulting in the C-RP operating only as a backup RP for the configured group. Without override, the C-RP has precedence over a static RP configured for the same multicast group or groups.

Examples

switch(config)# router pim6
switch(config-pim6)# rp-address 2001::01 ff08::1:3/64 ovverride
switch(config-pim6)# rp-address 2002::02 ff08::1:4/64
switch(config-pim6)# no rp-address 2002::02 ff08::1:4/64