fault-finder multicast-storm action

Syntax

fault-finder multicast-storm [action {warn | warn-and-disable}] [sensitivity {low | medium |high}]
no fault-finder multicast-storm [action {warn | warn-and-disable}] [sensitivity {low | medium |high}]

Description

Global command to configure multicast-storm. The no form of the command disables multicast-storm configuration on the port. The default sensitivity is medium and the default action is warn.

Parameters

warn

Log an event only

warn-and-disable

Log an event and disable the port

low

Low sensitivity

medium

Medium sensitivity

high

High sensitivity

Command context

config

Examples

switch(config)# fault-finder multicast-storm action warn
sensitivity     Configure the fault sensitivity level.

switch(config)# fault-finder multicast-storm action warn sensitivity
low             Low sensitivity.
medium          Medium sensitivity.
high            High sensitivity.

switch(config)# fault-finder multicast-storm action warn-and-disable
sensitivity     Configure the fault sensitivity level.

switch(config)# fault-finder multicast-storm action warn-and-disable sensitivity
low             Low sensitivity.
medium          Medium sensitivity.
high            High sensitivity.

switch(config)# fault-finder multicast-storm action warn-and-disable sensitivity high 
Global show command for auto-100 duplex Smart Rate port:
switch(config)# show fault-finder

Fault Finder

Fault ID              Sensitivity  Action
-------------------   -----------  ----------------
bad-driver            medium       warn
bad-transceiver       medium       warn
bad-cable             medium       warn
too-long-cable        medium       warn
over-bandwidth        medium       warn
broadcast-storm       medium       warn
loss-of-link          medium       warn
duplex-mismatch-hdx   medium       warn
duplex-mismatch-fdx   medium       warn
multicast-storm       high         warn-and-disable
link-flap             medium       warn