Viewing RIP interface information

To display RIP interface information, enter the show ip rip interface command at any context level.

Syntax:


show ip rip interface [ip-addr | vlan < vlan-id >]

The resulting display will appear similar to the following:

Output for the show IP RIP interface command

switch(config)# show ip rip interface

 RIP interface information

  IP Address  Status   Send mode  Recv mode  Metric  Auth
  ----------- -------- ---------- ---------- ------- ----
  100.1.0.1   enabled  V2-only    V2-only    1       none
  100.2.0.1   enabled  V2-only    V2-only    1       none
  100.3.0.1   enabled  V2-only    V2-only    1       none
  100.4.0.1   enabled  V2-only    V2-only    1       none

You can also display the information for a single RIP VLAN interface, by specifying the VLAN ID for the interface, or by specifying the IP address for the interface.

To show the RIP interface information for VLAN 1000, use the show ip rip interface vlan <vid> command.

RIP interface output by VLAN

switch# show ip rip interface vlan 4

 RIP configuration and statistics for VLAN 4

 RIP interface information for 100.4.0.1

  IP Address : 100.4.0.1
  Status     : enabled

  Send Mode  : V2-only 
  Recv mode  : V2-only 
  Metric : 1
  Auth : none

  Bad packets received : 0
  Bad routes received  : 0
  Sent updates : 0

For RIP interface output by VLAN field definitions, see Viewing general RIP information.

The RIP interface information also includes the following fields:

Bad packets received

Number of packets that were received on this interface and were not processed for any reason.

Bad routes received

Number of route entries that were received on this interface and were not processed for any reason.

Sent updates

Number of RIP routing updates that have been sent on this interface.

To show the RIP interface information for the interface with IP address 100.2.0.1, enter the show ip rip interface command:

The show IP rip interface output by IP address

switch# show ip rip interface 100.2.0.1

 RIP interface information for 100.2.0.1

  IP Address : 100.2.0.1
  Status    : enabled

  Send Mode : V2-only 
  Recv mode : V2-only 
  Metric : 1
  Auth : none

  Bad packets received : 0
  Bad routes received  : 0
  Sent updates : 0