Accessing system information (CLI)

Syntax:


show system [chassislocate | information | fans | power-supply | temperature]

Displays global system information and operational parameters for the switch.

`chassislocate`	Shows the chassisLocator LED status. Possible values are On, Off, or Blink.When the status is On or Blink, the number of minutes that the Locator LED will continue to be on or to blink is displayed. (See Command results for show system chassislocate command)
`information`	Shows global system information and operational parameters for the switch. (See Switch system information.)
`fans`	Shows system fan status. (See System fan status.)

Command results for show system chassislocate command

switch(config)# show system chassislocate

Chassis Locator LED: ON 5 minutes 5 seconds

switch(config)# show system chassislocate

Chassis Locator LED: BLINK 10 minutes 6 seconds

switch(config)# show system chassislocate

Chassis Locator LED: OFF

System fan status

switch(config)# show system fans

Fan Information
   Num | State | Failures
-------+-------------+----------
 Sys-1 | Fan OK | 0

0 / 1 Fans in Failure State
0 / 1 Fans have been in Failure State

Switch system information

switch(config)# show system

 Status and Counters - General System Information

  System Name        : Switch
  System Contact     :
  System Location    :

  MAC Age Time (sec) : 300

  Time Zone          : 0
  Daylight Time Rule : None

  Software revision  : T.13.XX     Base MAC Addr   : 001635-b57cc0
  ROM Version        : XX.12.12     Serial Number   : LP621KI005

  Up Time            : 51 secs     Memory - Total  : 152,455,616
  CPU Util (%)       : 3                    Free   : 100,527,264

  IP Mgmt - Pkts Rx  :0            Packet - Total  : 6750
            Pkts Tx  :0            Buffers  Free   : 5086
                                            Lowest : 5086
                                            Missed : 0