Configuring security settings using the CLI wizard

To configure the security settings using the CLI wizard, follow the steps below:

Procedure
  1. At the command prompt, enter setup mgmt-interfaces.

    The welcome banner appears and the first setup option is displayed (operator password). As you advance through the wizard, each setup option displays the current value in brackets [].

    Figure 1: Management Interface wizard configuration
  2. When you enter the wizard, you have the following options:
    1. To update a setting, type in a new value, or press Enter to keep the current value.
    2. To quit the wizard without saving any changes, press CTRL-C at any time.
    3. To access online Help for any option, press ?.

      After you have gone through each setup option, the wizard displays the summary configuration together with a prompt to save the changes.

  3. When the message appears asking if you want to save these changes, you have the following options:
    1. To save your changes, press Enter.
    2. To cancel any changes without saving, enter n and then press Enter.
      After pressing Enter, the wizard exits to the command line prompt.