Adding SNTP server addresses

You can configure one SNTP server address using either the Menu interface or the CLI. To configure a second and third address, you must use the CLI. To configure these remaining two addresses, you would do the following:

Creating additional SNTP server addresses with the CLI

Switch(config)# no sntp server priority 1 2001:db8::215:60ff:fe79:8980
Switch(config)# no sntp server priority 2


If there are already three SNTP server addresses configured on the switch, and you want to use the CLI to replace one of the existing addresses with a new one, you must delete the unwanted address before you configure the new one.