Disabling time synchronization without changing the TimeP configuration (CLI)

Syntax:

no timesync

Disables time synchronization by changing the Time Sync Mode configuration to Disabled. This halts time synchronization without changing your TimeP configuration. The recommended method for disabling time synchronization is to use the timesync command.

Example:

Suppose TimeP is running as the switch's time synchronization protocol, with DHCP as the TimeP mode, and the factory-default polling interval. You would halt time synchronization with this command:

switch(config)# no timesync

If you then viewed the TimeP configuration, you would see the following:

switch(config)# show timep

 Timep Configuration
  Time Sync Mode: Disabled
  TimeP Mode : DHCP Poll Interval (min): 720