device-profile name

Syntax

device-profile name <device-profile-name> no allow-tunneled-node

Description

Allows or disallows tunneled node when device profile is applied on that port.

Command context

config

Parameter

<device-profile-name>

Specifies the name of the device profile to be configured.

Usage

To create a device-profile named "test", execute the following command:
switch(config)# device-profile name test
To allow tunneled-node by the configured device profile parameter, execute the following command:
switch(device-profile)# allow-tunneled-node

Examples

switch(config)# device-profile name <device-profile-name>
 switch(device-profile)# 
 allow-jumbo-frames    Configure jumbo frame support for the device port.
 allow-tunneled-node   Configure Tunneled Node support for the device port.
 cos                   Configure the Class of Service (CoS) priority for
                       traffic from the device.
 egress-bandwidth      Configure egress maximum bandwidth for the device port.
 ingress-bandwidth     Configure ingress maximum bandwidth for the device
                       port.
 poe-max-power         Configure the maximum PoE power for the device port.
 poe-priority          Configure the PoE priority for the device port.
 speed-duplex          Configure the speed and duplex for the device port.
 tagged-vlan           Configure this port as a tagged member of the specified
                       VLANs.
 untagged-vlan         Configure this port as an untagged member of specified
                       VLAN.
Execute show run command to display the tunneled mode configuration in an enabled or disabled state:
switch(config)# show run
; J9625A Configuration Editor;
; Ver #0f:02.43.18.82.34.61.1c.28.f3.84.9c.63.ff.37.2f:da
hostname "switch"
snmp-server community "public" unrestricted
device-identity name "cpe" lldp oui 33bbcc
device-identity name "cpe" lldp sub-type 1
device-identity name "phone" lldp oui 112233
 
vlan 1
   name "DEFAULT_VLAN"
   untagged 1-28
   ip address dhcp-bootp
   exit
device-profile name "ram"
   exit
device-profile name "test"
   exit
device-profile type “scs-wan-cpe”
   associate "ram"
   enable
   exit
device-profile type-device "cpe"
   associate "ram"
   enable
   exit
device-profile type-device "phone"
   associate "default-device-profile"
   exit 
When allow-tunneled-node is disabled:
switch(config)# show run
; J9625A Configuration Editor;
; Ver #0f:02.43.18.82.34.61.1c.28.f3.84.9c.63.ff.37.2f:da
hostname "switch"
snmp-server community "public" unrestricted
device-identity name "cpe" lldp oui 33bbcc
device-identity name "cpe" lldp sub-type 1
device-identity name "phone" lldp oui 112233
 
vlan 1
   name "DEFAULT_VLAN"
   untagged 1-28
   ip address dhcp-bootp
   exit
device-profile name "ram"
   exit
device-profile name "test"
   no allow-tunneled-node
   exit
device-profile type “scs-wan-cpe”
   associate "ram"
   enable
   exit
device-profile type-device "cpe"
   associate "ram"
   enable
   exit
device-profile type-device "phone"
   associate "default-device-profile"
   exit