Fault Events
The following are the events related to fault.
Event ID: 327
Message | port <PORT_NUM>-Excessive undersized/giant packets. See help. |
Platforms | K, KA, KB, RA, WB, WC, YA, YB, YC |
Category | Fault |
Severity | Information |
Description | Port has been unblocked on VLAN by PVST. |
Event ID: 328
Message | port <PORT_NUM> Excessive jabbering/fragments. See Help |
Platforms | K, KA, KB, RA, WB, WC, YA, YB, YC |
Category | Fault |
Severity | Information |
Description | PVST root port has changed. |
Event ID: 329
Message | port <PORT_NUM> -Excessive CRC/alignment errors. See help. |
Platforms | K, KA, KB, RA, WB, WC, YA, YB, YC |
Category | Fault |
Severity | Information |
Description | Port has been blocked by MSTP. |
Event ID: 330
Message | port <PORT_NUM> -Excessive late collisions. |
Platforms | K, KA, KB, RA, WB, WC, YA, YB, YC |
Category | Fault |
Severity | Information |
Description | Port has been unblocked by MSTP. |
Event ID: 331
Message | port <PORT_NUM> -High collision or drop rate. See help. |
Platforms | K, KA, KB, RA, WB, WC, YA, YB, YC |
Category | Fault |
Severity | Information |
Description | MSTP root port has changed. |
Event ID: 332
Message | port <PORT_NUM>-Excessive Broadcasts. See help. |
Platforms | K, KA, KB, RA, WB, WC, YA, YB, YC |
Category | Fault |
Severity | Information |
Description | The number of configured MSTP instances exceeds the limit of instances permitted on a stack. |
Event ID: 333
Message | port <PORT_NUM> - Loss of Link |
Platforms | K, KA, KB, RA, WB, WC, YA, YB, YC |
Category | Fault |
Severity | Information |
Description | MSTP BPDU throttling is disabled because QinQ is enabled. |
Event ID: 334 (Severity: Warning)
Message | Port <PORT_NUM> - Security violation caused by MAC address <MAC_ADDRESS>. |
Platforms | K, KA, KB, RA, WB, WC, YA, YB, YC |
Category | Fault |
Severity | Warning |
Description | MSTP BPDU throttling is disabled because Meshing is enabled. |
Event ID: 380 (Severity: Warning)
Message | port <PORT_NUM> - Disabled due to speed mismatch. See help. |
Platforms | K, KA, KB, RA, WB, WC, YA, YB, YC |
Category | Fault |
Severity | Warning |
Event ID: 402 (Severity: Warning)
Message | Stack member <STACK ID> lost. |
Platforms | K, KA, KB, RA, WB, WC, YA, YB, YC |
Category | Fault |
Severity | Warning |
Event ID: 883 (Severity: Warning)
Message | Port failure. Port <PORT_ID> has been reset. |
Platforms | K, KA, KB, RA, WB, WC, YA, YB, YC |
Category | Fault |
Severity | Warning |
Event ID: 2671 (Severity: Warning)
Message | Port <PORT_ID> has been downgraded to 10/100. See www.hp.com/networking/device_help/nic_update for details. |
Platforms | K, KA, KB, RA, WB, WC, YA, YB, YC |
Category | Fault |
Severity | Warning |
Event ID: 2672 (Severity: Fatal)
Message | port <PORT_NUM> -Excessive link state transitions |
Platforms | K, KA, KB, RA, WB, WC, YA, YB, YC |
Category | Fault |
Severity | Fatal |
Event ID: 2673 (Severity: Fatal)
Message | port <PORT_NUM> -Port disabled by Fault-finder. |
Platforms | K, KA, KB, RA, WB, WC, YA, YB, YC |
Category | Fault |
Severity | Fatal |
Event ID: 2674 (Severity: Fatal)
Message | port <PORT_NUM> -Administrator action required to re-enable. |
Platforms | K, KA, KB, RA, WB, WC, YA, YB, YC |
Category | Fault |
Severity | Fatal |
Event ID: 2675 (Severity: Warning)
Message | port <PORT_NUM> -Excessive Broadcasts. Broadcast-storm control threshold <THRESHOLD_VALUE> pps exceeded. |
Platforms | K, KA, KB, RA, WB, WC, YA, YB, YC |
Category | Fault |
Severity | Warning |
Event ID: 2676 (Severity: Warning)
Message | port <PORT_NUM>-Excessive Broadcasts. Broadcast-storm control threshold <THRESHOLD_VALUE> percent exceeded. |
Platforms | K, KA, KB, RA, WB, WC, YA, YB, YC |
Category | Fault |
Severity | Warning |
Event ID: 5514 (Severity: Warning)
Message | port <PORT ID> is receiving excessive non-standard Ethernet preambles. If this reoccurs frequently- check the connected device to ensure it complies with the Ethernet standard. |
Platforms | K, KA, KB, RA, WB, WC, YA, YB, YC |
Category | Fault |
Severity | Warning |
Event ID: 5737
Message | port <PORT_NAME>-Excessive Multicasts. See help. |
Platforms | WC, YA, YB, YC |
Category | Fault |
Severity | Information |
Description | This message will be logged by fault finder module if there is multicast storm. |
Event ID: 5739 (Severity: Warning)
Message | port <PORT_NAME> -Excessive Multicasts. Multicast-storm control threshold <THRESHLD_VALUE> percent exceeded. |
Platforms | WC, YA, YB, YC |
Category | Fault |
Severity | Warning |
Description | This event is used to indicate fault-finder for multicast-storm that the threshold percent was exceeded. |
Event ID: 5740 (Severity: Warning)
Message | port <PORT_NAME> -Excessive Multicasts. Multicast-storm control threshold <THRESHLD_VALUE> pps exceeded. |
Platforms | WC, YA, YB, YC |
Category | Fault |
Severity | Warning |
Description | This event is used to indicate by fault-finder for multicast-storm that the threshold pps has been exceeded. |
Event ID: 5753
Message | Port-security disable timer set for port:<PORT_NAME> |
Platforms | WC |
Category | Fault |
Severity | Information |
Event ID: 5754
Message | port-security disable timer expired for port:<PORT_NAME> |
Platforms | WC |
Category | Fault |
Severity | Information |