System – SNMP

System–SNMP

Trap receivers: Displays all the trap receivers configured.

  • Each card represents a trap receiver configured.

  • To add a trap receiver, click the Add Trap Receiver (+) icon on the left side of the black panel.

  • To edit a trap receiver, select the Edit Trap Receiver icon on the receiver card.

  • To delete a trap receiver, select the Delete Trap Receiver icon on the receiver card.

  • The interface offers different sorting options, which can be viewed by hovering over the sort icons. Select one to apply the sort. Select the arrow next to the sort icons to switch between ascending and descending sorting.

  • Different sorting options are available, which can be viewed by hovering over the sort icons. Select one to apply the sort.

  • Select the arrow next to the sort icons to switch between ascending and descending sort order.

IP Configuration: Displays the IP Configuration for the Trap Source and Trap Response. To edit either the Trap Source or Trap Response, select the Edit Configuration icon in the upper right corner of the IP Configuration panel.

Community Names: Displays a list of all community names. To add a community name, select the Add Community Name icon (+) in the upper right corner of the Community Names panel.

Community Info: Select a community name in the table to display it in the Community Info tile.

  • To edit the community name, select the Edit Community Name icon in the upper right corner of the Community Info tile.

  • To delete a community name, select the Delete Community Name icon in the upper right corner of the Community Info tile.

General Traps: Displays the traps supported and indicates whether each is enabled or disabled. To enable or disable a trap:

  1. Select the Edit General Traps icon in the upper right corner of the General Traps tile.

  2. Check or clear the box to the right of the trap to enable or disable that trap.

  3. Click Save or Cancel.

Link Status Change Trap: Select the Expand icon on the left of the panel to view a table of ports and their link status change trap configurations.

  • Use the page controls at the bottom of the table to navigate all the ports.

  • If the Expand icon was previously selected, select the Collapse icon at the upper left of the panel to hide the table.

  • To edit the link status change trap configuration for a port, select the Edit Link Status Change Trap icon in the upper right corner of the panel.