Changing the RIP type on a VLAN interface

When you enable RIP on a VLAN interface, RIPv2-only is enabled by default. You can change the RIP type to one of the following on an individual VLAN interface basis:
  • Version 1 only

  • Version 2 only (the default)

  • Version 1 - or - version 2


[no] ip rip [v1-only | v1-or-v2 | v2-only]

To change the RIP type supported on a VLAN interface, enter commands such as the following:

switch(config)# vlan 1
switch(vlan-1)# ip rip v1-only
switch(vlan-1)# exit
switch(config)# write memory