Viewing a summary of OSPFv3 configuration information

Syntax

show ipv6 ospf3 [ general ]

Description

Displays the summary of OSPFv3 information, such as the areas configured, address ranges defined, interface information, timers, and virtual links.

Options

general

Displays the OSPFv3 general status information and other generic information.

Example output

This example shows the output for show ipv6 ospf3 command.

Switch# show ipv6 ospf3

 OSPFv3 Configuration Information

  OSPFv3 Protocol : Enabled
  Router ID : 10.0.8.35

 Currently defined areas:

                 Stub         Stub        Stub
Area ID   Type   Default Cost Summary LSA Metric Type   SPF Runs
--------- ------ ------------ ----------- ------------- --------
backbone  Normal 1            don’t send  Ospfv3 Metric
10.3.16.0 Normal 1            don’t send  Ospfv3 Metric
10.3.32.0 Normal 1            don’t send  Ospfv3 Metric

 Currently defined address ranges:

                             Prefix
  AreaID          LSAType    Advt   IPv6Addr
  --------------- ---------- ------ --------------
 OSPFv3 interface configuration:

                             Admin
  Interface   Area ID        Status   Type  Cost  Pri
  ---------- --------------- -------- ----- ----- ---
  vlan-55    0.0.0.1         Enabled  BCAST 1     1
  vlan-75    0.0.0.1         Enabled  BCAST 1     1
  tunnel-3   0.0.0.0         Enabled  P2P   1     1

 OSPFv3 configured interface timers:

             Transit Retransmit Hello    Dead
  Interface  Delay   Interval   Interval Interval
  ---------- ------- ---------- -------- ----------
  vlan-55    1       5          10       40
  VLAN-75    1       5          10       40
  tunnel-3   1       5          10       40

 OSPFv3 configured virtual interfaces:

                                  Xmit  Rxmt  Hello Dead
  Transit AreaID  Neighbor Router Delay Intvl Intvl Interval
  --------------- --------------- ----- ----- ----- ----------
  0.0.0.1         15.255.155.1    1     5     10    40