Mac-access-list extended configuration context

Syntax

[no] SEQ-NUM < permit | deny > < any | host > SRC-MAC | SRC-MAC-MASK < any | host > DST-MAC | DST-MAC-MASK < any | ETHERTYPE cos COS log
    

Used to configure an extended MAC ACL. The extended capabilities allow for matching on source MAC address, destination Mac address, EtherType, CoS, and VLAN. The VLAN value is only applicable when the MAC ACL is applied to a port or trunk interface.

permit

Packets matching the specified Ethernet Header information.

deny

Packets matching the specified Ethernet Header information.

any

Match packets with any source/destination MAC address.

host

Match packets with the specified source/destination MAC address.

SRC-MAC

Match packets belonging to the specified source/destination MAC address range.

SRC-MAC-MASK

The source MAC address group mask.

DST-MAC-MASK

The destination MAC address group mask.

<0x600-0xFFFF>

Match a specific EtherType protocol.

aarp

AppleTalk Address Resolution Protocol (AARP)

appletalk

AppleTalk/EtherTalk

arp

Address Resolution Protocol (ARP)

fcoe

Fibre Channel over Ethernet

fcoe-init

Fibre Channel over Ethernet Initialization

lldp

Link Layer Discovery Protocol

ip

Internet Protocol Version 4

ipv6

Internet Protocol Version 6

ipx-arpa

IPX Advanced Research Projects Agency (ARPA)

ipx-non-arpa

IPX non-ARPA

is-is

Intermediate System to Intermediate System

mpls-unicast

MPLS Unicast

mpls-multicast

MPLS Multicast

q-in-q

IEEE 802.1ad encapsulation

rbridge

RBridge Channel Protocol

trill

IETF TRILL protocol

wake-on-lan

Wake on LAN

log

Log a debug message when the MAC ACL rule is hit.

cos

Match packets with a specified 802.1Q Priority Code Point value.

vlan

Match packets with the specified VLAN value.

VLAN-ID

Match packets with the specified VLAN value.

<0-7>

Match packets with a specified 802.1Q Priority Code Point value.

NOTE:

Similar Command


(config)#ip access-list extended 100