Provisioning FUP with stacking disabled

Use the CLI command to provision an FP module in a standalone environment, with the specified flexible module type defined by the corresponding J-number. Preconfigure a flexible module before installing, as it allows the ports to be preconfigured and ready to use. If the modules are not preconfigured, the default configuration is used. If a module other than the preconfigured module type is inserted, the module is not activated.

Syntax

flexible-module <SLOT-ID> {type <J-NUMBER>}

Description

Specify a flexible module to be configured.

Parameters

  • SLOT-ID

    Specify an alphabetic device slot identifier A.

  • J-NUMBER
    Configure the type of the flexible module to be provisioned.
    • JL078A
    • JL081A
    • JL083A

Example output

switch(config)# flexible-module 
SLOT-ID               Enter an alphabetic device slot identifier

switch(config)# flexible-module A 
remove                Erases the flexible module configuration.
type                  Configure the type of the flexible module being 
                      provisioned
                       
                       
switch(config)# flexible-module A type 
JL078A               
JL081A               
JL083A

switch(config)# flexible-module A type JL078A

switch(config)# show running-config 
                                                 
Running configuration:

; JL322A Configuration Editor; Created on release #WC.16.05.0000x
; Ver #10:9b.3f.bf.bb.ef.7c.59.fc.6b.fb.9f.fc.ff.ff.37.ef:ad

hostname "Aruba-2930M-48G-PoEP"
module 1 type jl322a
flexible-module A type JL081A
include-credentials
snmp-server community "public" unrestricted
snmpv3 engineid "00:00:00:0b:00:00:e0:07:1b:e5:6b:00"
oobm
   ip address dhcp-bootp
   exit
vlan 1
   name "DEFAULT_VLAN"
   untagged 1-48,A1-A4
   ip address dhcp-bootp
   exit